Introduction:
JIC Fitting is a range of hydraulic fittings that's produced in accordance to the SAE J514 requirements. The acronym JIC stands for Joint Industry Council. It's also known as the JIC 37 degrees flare fitting because it's a thirty seven degrees flare seating surface. These fittings are used on oil hydraulic methods in many fields (gas delivery, fuel power application, shipbuilding, mobile hydraulic equipment, etc...). A JIC fitting structure has three segments that make a tubing assembly: installing, flare nut, and sleeve.

Material:
Materials used to fabricate JIC fittings include carbon steel and stainless steel SS316L.

Sizes:
JIC body and flare nut are available in outer diameter ("OD) sizes between 1/8" to 1 2". Sleeve has 2 different reading measurements, metric size (mm) & inch outer diameter ("OD). Sleeve size is available from 3mm to 50mm and 1/8" to 2". Fitting sizes are specified by the corresponding outside diameter of the tubing for the numerous kinds of tube ends.

Working Pressure:
The typical working pressure of the fittings ranges from 1000 to 5000 psi for different sizes and connections. The minimum burst stress is 4 times the working strain. The JIC fittings should be able to withstand two times the working strain for a period of one minute with no leakage or failure.
Remember to take note that the pressure rating of a same fitting could vary when it keto strong XP is it safe connected to various equipments.. For instance, if a fitting with a reduced performing pressure is connected to a pipe, it will result in an overall much reduce functioning strain. In all cases, often think about the lowest pressure as the optimum working pressure of the product.

So how does a JIC fitting works: For tube connections, the assembly operation starts off from the preparation of the hose. First, the nut and sleeve are inserted onto the end of a tube. With the usage of a flaring tool, create the conclusion of the tube to 37 degrees. Next, firm up the nut by using a spanner till the nut is firm and also the sleeve grips onto the tube. If the fittings are bench put together, the gripping actions might be determined by revolving the tubing manually as the nut is drawn down. When the tube will not anymore be driven by hand, the sleeve has gripped onto the tube. If this happens,, firm up the nut by turning it one full turn. This may vary slightly with various tubing materials, but for common practice, it is a very good rule to follow.

Configurations of JIC Fitting: Commonly made use of connection types be made up of: JIC/BSPP Male Connector, JIC/ NPT Male connector, JIC union, JIC/NPT Swivel Male Connector, JIC/BSPP Swivel Male Connector.

Brand of JIC Fittings:
HS Corporation is a Korean company specializing in JIC Fitting. Started in 1980, HS Corporation has more than 30 years of specialized experience in manufacturing fittings.